Ham 4 rotator manual

The rotator is mounted inside a tower (see Figure 4 4) to the flat tower plate by means of six (6) bolts furnished in the hardware kit. Use the following procedure: 5 1. Locate the rotator in the tower directly under the bushing. Note that the tower plate must be cut out to allow the connecting 8-wire cable to pass through the plate. • Read this manual completely before proceeding. The HAM IV rotator has been carefully designed and manufactured to give many years of trouble-free service when carefully and professionally installed. It consists of the strongest and best commercially available components. Page 4 D. With the rotator sitting in the upright position WIRING AND CHECK-OUT and connected to the control unit by the 8- A. . The Ham rotor is designed to support excep- tionally heavy antenna arrangements used by amateur radio operators, and provide for rotation of such an- tennas through a complete degree range. Position of the antenna is indicated on a meter in the control box. This rotor is built along the general lines of the original Bell.

HAM-IV Rotator Specifications: Wind Load Capacity (inside tower) 15 square feet: Wind Load (w/ Mast Adapter) square feet: Turning Power: pounds: Brake Power: pounds: Brake Construction: Electric Wedge: Bearing Assembly: Dual race/96 ball bearings: Mounting Hardware: Clamp Plates/Steel U-Bolts: Control Cable Conductors: 8: Shipping Weight: 24 pounds. • Read this manual completely before proceeding. The HAM IV rotator has been carefully designed and manufactured to give many years of trouble-free service when carefully and professionally installed. It consists of the strongest and best commercially available components. Page 4 D. With the rotator sitting in the upright position WIRING AND CHECK-OUT and connected to the control unit by the 8- A. Decide the wire gauge (size) required and wire cable, plug the control unit power cord. The rotator is mounted inside a tower (see Figure 4 4) to the flat tower plate by means of six (6) bolts furnished in the hardware kit. Use the following procedure: 5 1. Locate the rotator in the tower directly under the bushing. Note that the tower plate must be cut out to allow the connecting 8-wire cable to pass through the plate.

(antenna rotators). MODEL HAM-M. Series 1, 2, 3, 4, 5 precursor to HAM-IV. CLASS OWNERS MANUAL. REPAIR PARTS. MANUAL. SCHEMATICS. ISSUE G. The Tailtwister rotator consists of an extra heavy The Control Box is not weatherproof and must be located in the house, ham. The Ham IV has a better brake housing and wedge, a better ring gear, and a better limit The manuals for the rotor are available at the Hy-Gain web site.